Filter
Top Products
20 21
WARNING:
When servicing, use only identical Homelite replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.
REPLACING THE GUIDE BAR AND CHAIN
See Figures 34 - 43.
DANGER:
Never start the engine before installing the guide bar,
chain, drivecase cover, and clutch drum. Without all these
parts in place, the clutch can fly off or explode, exposing
the user to possible serious injury.
WARNING:
To avoid serious personal injury, read and understand all
the safety instructions in this section.
n Always place the switch in the STOP “ ” position before
you work on the saw.
n Make sure the chain brake is not set by pulling the chain
brake lever/hand guard towards the front handle to the
run position.
MAINTENANCE
Fig. 34
RUN POSITION
BAR MOUNTING NUTS
SCRENCH
Fig. 35
CLUTCH
COVER
GUIDE BAR
PLATE
BAR MOUNTING NUTS
Fig. 36
GUIDE BAR
NOTE: When replacing the guide bar and chain, always use
the specified bar and chain listed in the BAR AND CHAIN
COMBINATIONS section later in this manual.