Homelite UT08570 Blower User Manual


 
Page 11
OPERATION
Fig. 10
STARTING AND STOPPING
See Figures 8 - 9.
TO START:
Place the blower on a flat bare surface.
Set switch to ON (I).
Squeeze the throttle trigger fully and hold. Press trigger
lock lever down and release throttle trigger.
Slowly press the primer bulb seven (7) times.
Move the choke lever to the FULL CHOKE position.
Pull the starter handle sharply until engine attempts to run.
Do not pull the starter handle more than eight (8) times.
Move the choke lever to the HALF CHOKE position.
Pull the starter handle until the engine runs. Do not pull the
starter handle more than six (6) times.
Allow the engine to run 15 seconds, then set the choke
lever to the RUN position. Squeeze the throttle trigger to
release the trigger lock.
TO STOP:
Set the switch to OFF (O).
TO REMOVE BLOWER:
Move harness straps off the shoulders, let straps slide
down arms.
Grasp the straps and lower the blower to the ground.
WARNING
Do not allow familiarity with your product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
OPERATING THE BLOWER
See Figure 10.
Start the blower, refer to “Starting and Stopping” later in this
manual. Slip arm through harness strap and onto shoulder,
then repeat for the other shoulder. Adjust the straps to a
comfortable position, refer to “Adjusting Harness Straps”
earlier in this manual. Operate the blower from the right side
as shown in illustration.
To keep from scattering debris, blow around the outer edges
of a debris pile. Never blow directly into the center of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Operate blower at the lowest possible throttle speed to do
the job.
Check your equipment before operation, especially the
muffler, air intakes and air filters.
Use rakes and brooms to loosen debris before blowing.
AIR
FILTER
AIR
FILTER
Fig. 8
TRIGGER
LOCK
THROTTLE
TRIGGER
Fig. 9
PRIMER BULB
CHOKE LEVER
FULL
CHOKE
RUN
SWITCH
SWITCH
HALF
CHOKE