Filter
Top Products
8
ASSEMBLY INSTRUCTIONS:
EDGER GUIDE ASSEMBLY
See Figure 4.
1. Assemble the two plastic pieces of the edger guide
together using the short bolt, flat washer, lock washer
and wing nut.
2. Slide the edger guide to adjust it to the desired
trimming length.
3. Tighten the wing nut securely.
GRASS DEFLECTOR AND EDGER GUIDE ASSEMBLY
See Figures 5 and 6.
1. Remove the wing nut, flat washer, lock washer and bolt
from the Owner’s Kit.
2. Place the grass deflector over the shaft and bracket.
3. Slide the assembled edger guide over the tabs on the
grass deflector and bracket.
4. Place the bolt through the slots in the tabs on the grass
deflector and trimmer.
NOTE: Ensure the slots are aligned before installing
the bolt.
5. Install the flat washer, lock washer and wing nut.
6. Tighten the wing nut securely.
ASSEMBLY
Fig. 4
TABS
Fig. 5
Fig. 6
WING NUT
LOCK
WASHER
FLAT WASHER
SHORT BOLT
EDGER GUIDE
PIECES
ASSEMBLED
EDGER GUIDE
WING NUT
LOCK
WASHER
FLAT
WASHER
LONG BOLT