Filter
Top Products
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and move the
motion control levers outward to the park
position when leaving the machine unattended,
even if just for a few minutes.
Adjusting the Height of Cut
1. Raise the height-of-cut lever to the transport
position, cutting height position G (also the
4-1/2 inch [115 mm]) (Figure 21).
Figure 21
1. Height-of-cut lever 2. Height-of-cut positions
2. To adjust the height of cut, pull inward and up on
the lever and move it to the desired position.
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
1. Raise the seat and loosen the adjustment knob just
enough that seat can move (Figure 22).
Figure 22
1. Adjustment knob
2. Move the seat to the desired position and tighten
the knob.
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 23).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 23).
G005062
1
2
3
4
Figure 23
1. Control arm shaft 3. Slotted, upper hole
2. Control lever
4. Bolt
3. Repeat the adjustment for the opposite control
lever.
21