Filter
Top Products
10 – English
TROUBLE SHOOTING
Start-up sequence
Code not accepted
A long beep when pressing "B" indi-
cates that the mower has not registered
the code, but will run for 2 minutes and
then stop, probably signalling "no code"
(2 beeps/second).
No sound
Battery level too low.
2 beeps / 10 seconds
This indicates that the batteries are
charging. The mower will start automati-
cally when charged.
Mower starts backwards
When stopping it will signal "trapped"
(1 beep/second). This indicates that the
microswitches are jammed. Other
failures when signalling "trapped" might
be blocked wheels or cutting disc.
Wait 1 minute and then
enter the code
A short beep should be heard when
pressing every button.
Code accepted
Mower starts
Switch on the power switch
Long beep
The batteries have enough power to
run the electronics.
Mower starts and then
stops almost immediately
The mower will signal 2 beeps/second.
There is not enough power to run the
mower properly. Charge another 60
minutes. If this is not enough, replace
the batteries.
Charge 60 min
Switch in "off" position.
Eng-SOL VERK 98-01-15, 10.0710