Filter
Top Products
Page 3SKU 97736 For technical questions, please call 1-800-444-3353.
Never allow people or animals to stand 7.
or climb on this product.
Pinch point warning: Use caution to 8.
avoid pinching ngers when assembling
and setting up this unit.
Adults only should perform the assembly 9.
and set-up of this product.
When in use, make sure all Legs of the 10.
product are at on the ground.
The warnings, precautions, and 11.
instructions discussed in this instruction
manual cannot cover all possible
conditions and situations that may occur.
It must be understood by the operator
that common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
SAVE THESE
INSTRUCTIONS.
SPECIFICATIONS
Construction
Material
Unnished Fir
Yellow/Green Zinc Plated Steel Bolts,
Washers, Nuts, and Screws
Weight Capacity
400 Pounds Total
(Distributed Evenly)
Umbrella Hole
Diameter
1-5/8”
Waterproof
Water Resistant
No
UNPACKING
When unpacking, check to make sure that
the item is intact and undamaged. If any parts
are missing or broken, please call Harbor Freight
Tools at the number shown on the cover of this
manual as soon as possible.
ASSEMBLY
Note: For additional information regarding the
parts listed in the following pages, refer to the
accompanying illustrations.
Attach the two Folding Beams (2) 1. ush to
the inner side of the Table Top (5), using
six Bolts each with two Washers and one
Nut (9). (See Figure A.)
NOTE: 2. The Bolts and Washers (9)
should be inserted from the outside of
the Table Top (5) into the Folding Beams
(2). (See Figure A.)
Place and align the Short Bench Top (8) 3.
ush on the two Bench Supports (4).
(See Figure B.)
Fasten the eight Screws (11) into the 4.
pre-drilled holes on the Short Bench
Top (8) to the Bench Supports (4). (See
Figure B.)
FIGURE A
BOLTS, WASHERS, NUTS (9)
FOLDING BEAM (2)
TABLE TOP (5)
FIGURE B
SHORT
BENCH
TOP
(8)
BENCH SUPPORT (4)
SCREWS (11)