Filter
Top Products
Page 19For technical questions, please call 1-800-444-3353.SKU 96156
If any emission related part on your engine is defective, the part will be
repaired or replaced by HFT.
Owner’s Warranty Responsibilities
As the engine owner, you are responsible for the performance •
of the required maintenance listed in your Owner’s Manual. HFT
recommends that you retain all receipts covering maintenance
on your engine, but HFT cannot deny warranty solely for the lack
of receipts or for your failure to ensure the performance of all
scheduled maintenance.
As the engine owner, you should, however, be aware that HFT •
may deny you warranty coverage if your engine or a part has
failed due to abuse, neglect, improper maintenance, or unap-
proved modications.
You are responsible for shipping your engine to a HFT warranty •
station as soon as a problem exists. Contact the HFT Customer
Service department at the number below to make shipping arrange-
ments. The warranty repairs should be completed in a reasonable
amount of time, not to exceed 30 days.
If you have any questions regarding your warranty rights and
responsibilities, you should contact the Harbor Freight Tools Customer
Service Department at 1-800-444-3353.
Harbor Freight Tools Emission Control Defects
Warranty Provisions
1. Length of Coverage
HFT warrants to a rst retail purchaser and each subsequent
purchaser that the engine is free from defects in materials and
workmanship that cause the failure of warranted parts for a
period of two (2) years after the date of delivery to the rst retail
purchaser.
2. No Charge Repair or Replacement
Repair or replacement of any warranted part will be performed at
no charge to the owner if the work is performed through a warranty
station authorized by HFT. For emissions warranty service, contact
the HFT Customer Service Department at 1-800-444-3353.
3. Consequential Damages Coverage
Coverage under this warranty shall also extend to the failure of
any engine components caused by the failure of any warranted
part while it is still covered under this warranty.
4. Coverage Exclusions
Warranty claims shall be led in accordance with the provisions
of the HFT warranty policy explained in the box at the top of the
previous page. HFT shall not be liable for any loss of use of the
engine, for any alternative usage, for any damage to goods, loss of
time, or inconvenience. Warranty coverage shall also be excluded
for any part which fails, malfunctions, or is damaged due to failure
to follow the maintenance and operating instructions set forth in
the Owner’s Manual including, but not limited to:
Use of parts which are not authorized by HFTa)
Improper installation, adjustment or repair of the engine or b)
of any warranted part unless performed by an authorized
warranty center
Failure to follow recommendations on fuel use contained in c)
the Owner’s Manual
Improper or inadequate maintenance of any warranted d)
parts
Repairs performed outside of the authorized warranty service e)
dealers
Alterations by changing, adding to or removing parts from f)
the engine.
5. Service and Maintenance
Component parts which are not scheduled for replacement as
required maintenance or are scheduled only for regular inspection
to the effect of “repair or replace as necessary” are warranted for
the warranty period. Any warranted part which is scheduled for
replacement as required maintenance is warranted for the period
of time up to the rst scheduled replacement point for that part.
Any replacement part, provided it is equivalent in durability and
performance, may be used in performance of maintenance or
repairs. The owner is responsible for commissioning a qualied
technician/mechanic to perform all required maintenance, as
outlined in the Inspection, Cleaning, and Maintenance section in
this manual.
6. Warranted Parts
1) Fuel Metering System
Carburetor and its internal parts.i)
Fuel pump (if so equipped).ii)
Cold start enrichment system.iii)
2) Air Induction System
Intake pipe/manifold.i)
Air cleaner.ii)
3) Ignition System
Spark plug.i)
Magneto ignition system.ii)
4) Catalyst System (if so equipped)
Exhaust pipe stud.i)
Mufer.ii)
Catalytic converter (if so equipped).iii)
5) Miscellaneous Items Used in Above Systems
Vacuum, temperature and time sensitive valves and i)
switches.
Hoses, belts, connectors, and assemblies.ii)