Filter
Top Products
SKU 94138 Page 4
Unpacking
When unpacking, check to make sure the following parts are included.
Hand Held Metal Detector Wand
Carrying Case
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Operation
First install one 9 volt battery (not included).
1. Slide open the battery compartment cover,
located at the base of the handle.
2. If there is an old battery in place, remove it.
Insert one 9 volt battery (not included) into the
battery compartment. Be sure that the polarity
of the battery matches the correct poles
marked “+” and “-”. If the battery is installed
improperly, the detector can be damaged.
3. Slide the battery compartment cover back
in place. Be sure it is closed tight.
NOTE: This hand wand metal detector has a
low battery warning system.
When the battery starts to get low, the detector will make a “chirping” sound
instead of the normal steady tone when encountering metal. Also, the LED
light will flash on and off rapidly when near metal. In this situation, replace the
battery.
NOTE: You may use rechargeable batteries with this detector (not included).
If using rechargeable Nickle-Cadmium battery, you may use a recharging unit
(not supplied) plugged into the recharge jack.
WARNING: Do not attempt to recharge Alkaline or other non-rechargeable
batteries; they may explode.
The battery compartment