Filter
Top Products
SKU 92050 For technical questions please call 1-800-444-3353. Page 4
2. Attach Front (3) to both Sides (2). Make certain that all sides are square and that edges
overlap appropriately. Insert Bolts (11) through each hole in the corner and thread on
Nuts (11)-see assembly diagrams.
3. Connect Rear (1), both Sides (2) and Front (3) (as assembled in steps 1 and 2) to
Top Frame (8)- see Figure 2.
Connect (8) to (1), (2) and (3) with Bolts and Nuts (11).
4. When attaching the Top Frame (8), make certain that the bolt holes at the end of the Top
Frame (8) line up underneath the bolt holes of the Rear (1) and Front (3). Make certain that
the Bolts (11) are inserted from the outside.
5. Set the Cross-Beams (9) so that there are three on each side of the Greenhouse. Line them
up with the corresponding holes-see Figure 3 and the Assembly Diagram.
6. Attach the Window Lower Support (10) to the Center Cross-Beam (9) as shown in Figure 3.
Use Nut and Bolt (11) to secure in place. The square head of the Bolt (11) will slide into
place - see Figure 3.
7. Attach Window (7) to Top Frame (8). Set the Plastic Panel (7) so that it is supported by the
Panel Lower Support (10) and the Top Frame (8). Test to make certain that the Small Plastic
Panel (7) moves smoothly and adjusts with no problems.
8. Place all of the plastic Side Panels (4) into the spaces on both walls of the Greenhouse. Set
the Metal Holding Clip (12) on each side to hold the plastic Side Panels in place-see Figure 4.
9. Place seven Roof Panels (5) along the top of the Greenhouse. Place the smaller
Top Roof Panel (6) into space on top of the Greenhouse (below Window (7). Use the
Metal Holding Clip (12) on each side to hold each plastic panel in place- see Figure 4.
Before assembling the plastic panels, remove the protective plastic covering from each one.
(8)
Figure 2-Part (8) to Top
(10)
Figure 3-Part 10 to Cross-beam (9)
9
9