Filter
Top Products
SKU 91924 Page 11
For technical questions, please call 1-800-444-3353.
6. To change the angle that the snow is ejected, rotate the Height Control Lever to
unlock it. Then press down or pull up on the Handle as needed to move the unit to
the desired setting. Rotate the Height Control Lever to lock the unit into its new
setting.
7. You can adjust whether the snow is
ejected forward, or to the left or right. To
change the angle at which snow is
ejected, push the Direction Control Lever
down slightly, rotate it to the left, right, or
center as required, then allow it to come
back up. This will change the orientation
of the Direction Flaps as desired.
8. To operate the Snow Thrower, grasp the
Handle firmly. Press in the Safety and,
while holding it in, squeeze the Trigger.
The machine will begin to operate imme-
diately.
Height Control
Lever
Direction Control
Lever
Safety
Trigger
Direction Flaps
NOTE: To stop the machine, remove your
hand from the handle, releasing the
Trigger.
9. Roll the Snow Thrower slowly for-
ward over the snow. Observe the di-
rection that the snow is being thrown.
If necessary, stop working and ad-
just the throwing height or direction.
10. Do not force the Snow Thrower
through the snow. Listen to the motor
as you work. If the motor slows down
excessively, pull the Snow Thrower
back to allow the motor to regain speed,
and roll the machine forward at a slower
rate.
11. When you reach the end of a row, be
aware of where the thrown snow will
go. You may have to adjust your direc-
tion or the throwing height to manage
the direction of thrown snow.
REV 11/04