Harbor Freight Tools 90729 Landscape Lighting User Manual


 
Page 5SKU 90729 For technical questions, please call 1-800-444-3353.
Operation
1. Remove the Cap and turn the switch to “ON”. Replace the Cap. Now charge the
Solar Light in direct sunlight for at least 3 sunny days.
This period is called the “Charging Period” because, during the initial three days, the
lamp may not illuminate up to its full duration.
2. You will only need to turn on the unit once, and from then on it will switch on and off
automatically. See FIGURE 3.
Note: We recommend testing the light by waiting until after the 3 day initial charge period
and then taking the Solar Light indoors into a dark room to make sure it comes on
automatically.
Troubleshooting
Dim Light:
1. The on/off switch contacts may be poor. Turn the switch on and off several times to
alleviate the problem.
2. The battery may be low or under charged. Make sure the Solar Light is located in an
unobstructed location where it will receive 8 hours of sun. Allow the battery to
recharge for 5 full, sunny days. Overcast days will limit performance.
3. Dirty Solar Panel (on top of the Cap). A dirty Solar Panel will not allow the unit to
charge, shortening the life of the battery. Clean the Solar Panel regularly with a damp
cloth. Do not use detergents or solvents.
No Light:
1. An external light source (i.e. streetlight, porch light, flood light) may prevent the light
from turning on. Reposition the Solar Light.
2. Batteries may need recharging.
FIGURE 3
Switch
Cap
LED
Switch
REV 05/05