Filter
Top Products
Technical Information
Recommended water pressure 45-80 psi
Max. water pressure 145 psi
Recommended hot water temp. 10° - 140° F*
Max. hot water temp 165°F*
Hole size in mounting surface
valves 1¼"
spout 1⅜"
spout retaining pin ³⁄₁₆"
Max. mounting surface depth 1⁹⁄₁₆"
Max ow rate 10 gpm
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.
3-Hole Roman Tub Rough
06607000
Installation Considerations
For best results, this unit should be installed by a licensed, professional plumber.
Large dierences in pressure between the hot and cold supplies should be balanced.
The included connecting tubes are type “K” copper tubing. If an installation dierent from the one
shown here is desired, the plumber may provide his own copper tubing.
To insure proper t of the trim, this valve must be installed after the mounting surface is nished and
made watertight.
This valve requires ½" hot and cold supply lines (not included)
The hot and cold water supplies should be ushed thoroughly before installation of this rough valve.
Damage to the cartridges caused by debris is not covered by the warranty.
•
•
•
•
•
•