Filter
Top Products
22 PNEG-1597 Sweep Tractor Assembly Instructions
3. Assembly
End Wheel Assembly
NOTE: If installing sweep tractor to an existing sweep, the current end wheel components must
be removed.
1. Connect stub into flighting using a 5/8" x 4" long hex head cap screw and 5/8" nylon lock nut.
2. Install bearing stand onto the stub shaft and bolt it to the sweep shield using a 3/8" x 3" hex head
cap screw, a 3/8" x 3" long carriage bolt, flat washers, and nylon lock nuts.
3. Install the end wheel and collar onto the end of the stub shaft. Lock the collar in place with a
1/2" x 3-1/2" long hex head cap screw and 1/2" nylon lock nut.
Figure 3L End Wheel Assembly
Sweep shield
Bearing stand weldment
Stub shaft
End wheel
Sweep flight
Collar