Filter
Top Products
H8191 3600 PSI Diesel Pressure Washer
-21-
Fuel Filter Change
Refer to the part breakdown on Page 27 for identi-
fication of components in the following steps.
To change the fuel filter:
1. FOLLOW SHUTDOWN PROCEDURE AND
ALLOW ENGINE TO COOL!
1. Drain the fuel tank by removing the fuel tank
drain plug (
Figure 25). Use a funnel and cer-
tified fuel container to capture the fuel as it
drains.
Figure 26. Removing the fuel filter.
4. Insert a new filter, making sure the gasket at
the base of the fuel filter and the gasket at the
base of the fuel valve are in place.
5. Fasten the fuel valve nuts securely.
6. Fasten the fuel tank drain plug securely.
Note: If you have difficulty removing the fuel
filter, you may find it easier with the fuel tank
removed entirely. To do this, refer to the parts
breakdown on
Page 27, remove the upper
and lower fuel lines, and remove the upper
tank bracket. Once the tank is removed, the
fuel filter can be removed and replaced more
easily. Be sure to reattach and securely fas
-
ten any fuel lines or brackets you remove.
Fuel Valve
Fuel Filter
Figure 25. Fuel tank drain plug and fuel valve.
2. Remove the two hex nuts shown in Figure
25. These hex nuts hold both the fuel valve
and the fuel filter in place.
3. Remove the fuel tank cap and extract the fuel
filter through the top of the tank as shown in
Figure 26.
Fuel Valve
Fuel Tank Drain Plug
Hex Nuts