Grizzly G9298 Brush Cutter User Manual


  Open as PDF
of 24
 


6.         
Step 5
7.       

Note: Use the pattern illustrated in Figure 5
to aid in positioning the edge finder for the
above procedure.
1
2
3
4
5
6
Figure 5.
Vertical Position Alignment
         
  

To verify the front-to-back alignment of the
rotary table:
1. 
2. 
        

3. 

       
      


4.  Step 3     

To center the rotary table with the mill spin-
dle:
1. 

Note: Any runout of the center will have to be
determined and accounted for in the following
steps.
2. 

Figure 6
Edge
Finder
Lathe
Center
Rotary
Table
Top View
Figure 6.

3. 



        


Note: Be sure to take into account any back-
lash when moving the mill table.
 previous next