Grizzly G9298 Manual

A SERVICE OF

next previous





Installation



       

       

       



       

Surface Care Page 18



Horizontal Position

1. 

2.       





3.         

      





4.       

        

        



5. 

         





6. Alignment 

Page 9

You MUST properly secure the rotary table

to the mill table to prevent unexpected

movement during operation, which could

result in personal injury or damage to the

workpiece.

Vertical Position







        









     

         

        





To install the rotary table in the vertical posi-

tion:

1. 

2.      



3. 

    

       









    



4. 



5. Alignment 

Page 9

NOTICE

Make sure the rotary table handwheel is free

of obstructions. Depending on your setup,

the rotary table may need to be blocked up

or mounted so the handle is hanging over

the edge of the mill table. After installation,

carefully check for any possible obstruc-

tions that may interfere with the rotary table

or its handwheel.