Filter
Top Products
Operating - 15
OPERATING
Starting Engine
c
1. Stand on operator’s platform.
2. Lock park brake.
c
MX20091
3. Put motion control levers (A) in the NEUTRAL position.
4. Push PTO switch knob (B) down to disengage PTO.
5. Move throttle lever (C) to set engine speed at the 1/2 to 3/4 fast
position.
6. Position choke knob (D):
• Cold engine: Pull knob up to the CHOKE position.
• Warm/Hot engine: If necessary, pull knob up to the CHOKE position.
7. Turn key switch (E) to the START position.
8. Release key to the RUN position when engine starts.
9. With engine started:
• Push choke knob to the OFF position.
• Move throttle lever to the FAST position.
• Unlock park brake.
Engaging Mower
c
1. Adjust mower deck to desired cutting height.
2. Start engine.
c
MX20091
3. Move throttle lever (A) to the 1/2 to 3/4 fast position.
4. Unlock park brake.
NOTE: In cold weather or with a new machine, allow engine to reach
operating temperature before engaging PTO to prevent engine from
stalling.
5. Pull PTO knob (B) up to engage mower deck.
6. Move throttle lever to the fast position (C).
NOTE: The travel speed and turn rate will vary with the amount that
the motion control levers are moved.
7. Push motion control levers (D) forward slowly. Mow at a safe travel
speed.
Stopping the Engine
c
1. Lock park brake.
2. Reduce engine speed to half-throttle.
3. Turn key switch to STOP position (C).
4. Remove key.
CAUTION: Avoid injury! Engine exhaust fumes contain
carbon monoxide and can cause serious illness or death.
Move the machine to an outside area before running the
engine.
Do not run an engine in an enclosed area without adequate
ventilation.
• Connect a pipe extension to the engine exhaust pipe to
direct the exhaust fumes out of the area.
• Allow fresh outside air into the work area to clear the
exhaust fumes out.
CAUTION: Avoid injury! Clear mowing area of all bystanders
when operating this machine. Thrown objects could cause
serious injury or death.
Keep hands and feet away from blades and discharge
opening.
Do not mow in reverse unless absolutely necessary.
IMPORTANT: Avoid damage! To help prevent damage to PTO
clutch:
• Do not engage PTO with throttle in the fast position.
IMPORTANT: Avoid damage! To help prevent engine backfiring,
throttle lever should be set at the half-speed position prior to
stopping the engine.
Do not stop engine when mower is on a slope of more than 30
degrees for an extended period of time. Oil may run through valve
train into carburetor and muffler.