Filter
Top Products
4.
5.
Align
the two holes nearest
the
drive
shaft
with the holes in the rear hitch.
Fasten
the
tiller to the rear hitch with the
two hitch
pins.
Apply multi-purpose
grease
to
the
square
shaft of
the
universal
joint.
Put
the
shaft
in
the tube
of
the universal
joint
on the tiller.
See figure 3.0-3.
6.
Pull
the
locking
collar toward the
universal
joint
and
hold it in that
position.
Slide the
locking collar half way
on the axle
drive
shaft and
release the locking
collar. Push
the locking
collar on
the
axle drive
shaf t
until
it
locks in
position.
See
figure
3.0-4.
1
-
Square
Shaft
2
-
Tube
3
-
Grease
Fitting
Figure
3.0-3
1 -
Locking
Collar
2
-
Axle Drive
Shaft
(not
shown)
Figure
3.0-4
the
2.
3.
1.
Remove the two hitch
tiller to the
rear hitch.
Remove the tiller from
4.0
HOW TO
DISCONNECT
THE TILLER
FROM THE
TRACTOR
Pull the locking collar toward the
universal
joint
and remove
it from the
axle
drive
shaft.
See
figure
3.0-4.
a,
pins
that fasten
See
figure
3.0-2.
the rear hitch.