Filter
Top Products
INJECTION
HAZARD
%i
penetrate the skin and cause extremely serious
Fluids under high pressure from spray or leaks can
injury, including the need for amputation.
NEVER point the spray gun at anyone or any part of
the
body.
NEVER put hand or fingers over the spray tip.
NEVER try to stop or deflect leak$with your.hand or
body.
ALWAYS
have the tip guard in place when spraying.
MEDICAL
TREATMENBi
If any fluid appears to penetrate your skin, get
EMERGENCY MEDICAL CARE
AT
ONCE.
Tell the doctor exactly what fluid was injected. For
DO
NOT
TREAT
AS
A
SIMPLE CUT.
treatment instructions have your doctor call the
~
NATIONAL
POISON
CENTER NETWORK
($1
2)684
-6669
AVOID
COMPONENT
RUPTURE
Even after you shut off the gasoline engine, there is
release
it
by triggering the gun.
So
before removing
high p.ressure
in
the pump, hose and gun'until you
the spray tip or servicing the unit, always shut offthe
unit
and
trigger the gun to release pressure.
Be sure that all accessory items and system
components
will
withstand the pressure developed,
NEVER exceed the pressure rating
of
any component
personal safety,
as well as the function
of the
in
system.,NEVER
alter or modify equipment
-your
equipment, isatstake. Maximum working
pressure
3400
PSI
(234 bar).
Before each use, check hose for weak, worn ordamaged
conditions caused by traffic, sharp corners, pinching or
kinking. Tighten all fluid connections securely before
each use. Replace any damaged hose.
with
Buna-N and
PIC
or neoprene cover'of hose.
Do
not usechemicalsor agentswhich are not compatible
Do
not leave a oressurized unit unattended. Shut
off
the
FBWE
Do not spray flammable liquids. Do not operate the
.engine where combustible fumes or dust may be
present.
GAS
ENQIINE
PRECAUTIONS
NEVER
fill
fuel tank while engine is running or hot.
Avoid the possibility of spilled fuel causing
a
fire.
Always refuel slowly to avoid spillage.
NEVER operate engine in a closed building unless the
carbon monoxide, apoisonous. odorlessand invisible
exhaust is piped outside. The exhaust contains
gas, which,
if breathed, may cause serious illness or
possibly death.
NEVER
make adjustments on machinery while
it
is
connected to the engine; first remove the ignition
cable from the spark plug. Turning over the
machinery by hand during adjusting or cleaning
serious injury to the operator.
might .start the engine and machinery. causing
NEVER run the engine with governor disconnected,
or operate
at
speeds
in
excess of
3600
RPM load:
Precaution
is
the best insurance against an accident.
When starting the engine, maintain a safe distance
from moving parts of.the equipment.
..
GE~~R~~~~~
NEVER run the unit with the.belt guard removed.
Keep clear of moving parts when the unit is running.
Observe detergent manufacturer's safety
precautions. Avoid~getting detergent or other liquids
in your eyes. Follow the directions on the.container
regarding conract
with
eyes,, nose, and skin,
protect your eyes
from
the spray as well as
any debris
breathing fumes,
etc: Always wear full
goggles to
dislodged by the spray. If necessary, wear gloves or
other protective clothing.
If
antidotes or treatment
are recommended,.be prepared to use them.
DON'T
spray toxic chemicals such as insecticide or
weed killer.
unit and release pressure before leaving.
~~~ ~
IMPORTANT ..
,
United States Government safety standards have been adopted under the Occupational Safety and Health Act.
These standards
-
particularly the General Standards, Part
1910,
and the Construction Standards, Part
1926-
should be consulted in connection
with
your use of airless spray equipment,
2
801-643
..