Filter
Top Products
~
BNG
HIGH
PRESSURE SPRAY CAM CAUSE SERIOUS INJURY.
FOR
PROFESSIONAL
USE
ONLY.
OBSERWE
ALL WARNINGS.
Read
and
understand
all
instruction
manuals
before
operating
equipment.
FLUID INJECTION HAZARD
General
Safety
This pressure washer generates very
high
fluid
pressure. Spray from the gun, leaks or ruptured
components can inject fluid through your skin and into
your body and cause extremely serious bodily injury
including theneedforamputation. Als0,fluid injectedor
splashed into the eyes or on the skin can cause serious
damage.
NNER
point the spray gun or wand at anyone
of
at any
part of the body.
NNER
put hand or fingers over the
spray tip.
ALWAYS
follow the Pressure Rellef Procedure, before
cleaning or servicing any part of the sprayer.
NNER
try
to
stop or deflect leaks with your hand or
body.
properly before each use.
Be sure equipment safety devices are operating
Medical
Treatment
If
any
fluid
appears
to
penetrate your skin, get
NOTTREAT AS A SIMPLE CUT. Tell the doctor exactly
EMERGENCY MEDICALTREATMENTATONCE.
DO
what fluid was injected.
NOTE TO PHYSICIAN: lnjection
in
the skin
is
a
traumatic
injufg
It
Is
Important
to
treat the
Injury
surglcally
as soon
as
posslble.
Do
not delay
treatment
to
research toxicip Toxicily
is
a
concern with some exotic coatings injected
directw into the bloodstream. Consultation with a
plastic surgeon or reconstructive hand surgeon
may be advisable.
Pressure
Relief Procedure
To
reduce the risk
of
serious bodily Injury, including fluid
injection and splashing in the eyes or on the skin,
always follow this procedure whenever you stop
spraying for more than
10
minutes, when shutting down,
and before checking or repairing any part of the system.
1.
Engage the trigger safety latch.
2.
Turn the sprayer
off.
3.
Disconnect the electrical supply.
4.
Shut
off
the water supply.
5.
Disengage the trigger safety latch and trigger the
safety latch again.
gun
to
relieve pressure, and then engage the trigger
6.
Before long-term (overnight) storage, disconnect
the water supply and disconnect the electricity.
Spray
Gun
Safety Devices
Be sure all gun safety devices are operating properly
the gun; this can cause a malfunction and result in
before each
use.
Do not remove or modify any part of
serious bodily
injury.
SAFm LATCH:
Whenever you stop spraying for a
moment, always set the gun safety latch in the engaged
0r"safe" position, making the guninoperative. Failure
to
properly
set
the safety latch can result in accidental
triggering of the gun.
cleaning
or
changing spray
tips.
If
a
spray tip
clogs
SPRAY
TIP
SAFm
Use extreme caution
when
while spraying, engage the gun safety latch
immediately.
ALWAYS
follow the Pressure Relief
Procedure and then remove the spray tip
to
clean it.
..
..
.
..
2
308-522