Filter
Top Products
the unit.
Refer to the engine instruction booklet provided with
Install Wheels and Handle
axle and secure with the 1/2 inch locknuts provided.
Slide the axle into the frame. Slide the wheels onto the
and lockwashers provided.
Attach the handle with the
4
screws, nuts, flat washers
Install
Hose
and Spray Gun
Connect the spray hose to the spray gun by inserting
the pin at the end of the hose into the quick disconnect
coupler on the gun. Connect the hose to the fluid outlet
in the same way.
Remove the tape from the cap
on
top of the pump.
Cleaning Accessories
For spraying detergent or other cleaning solution, we
recommend using a chemical injector kit. See Ac-
and operation.
cessories and instruction manual 801-192 for installation
For removing rust
and
old paint we recommend using
a
water sandblaster. See Accessories and instruction
manual 801-190 for installation and operation.
Connect
To
Water Supply
CAUTON
Before attaching to water supply, check local
plumbing code regarding cross-connection to
water supply.
pump in
a
direct supply system.
Do
not exceed 160"
F
(70"
C)
water temperature to
your city water supply to the unit's
3/4
in. garden hose
Connect
a
hose with
at
least
a
3/4
in. (19 mm)
ID
from
threaded inlet. The supply hose should not be more
than
50
ft. (15 m) long.
NOTE:
For
a
direct
SUDO~V
svstem.
your
water
source
at
the unct 'must'have
a
flow
rate of
AT
LEAST5
GPM
(19
LITER/MIN).
contact our Customer Service. Department for
If your operating conditions are different from above.
assistance.
801-191
3