Filter
Top Products
..
ENGINE
KILL
LEVER
7
P,
\
LSPRAY
HOSE
the unit.
Refer to the engine instruction booklet provided with
Install Hose and Spray Gun
the pin
at
the end of the hose into the quick
Connect the spray hose to the spray gun by inserting
the fluid outlet
in
the same way.
disconnect coupler
on
the
gun. Connect the hose
to
Cleaning Accessories
For spraying detergent
or
other cleaning solution, we
Accessories and instruction manual 801-645 for
recommend using
a
chemical injector kit. See
installation and operation.
For removing rust and old paint we recommend using
a water sandblaster. See Accessoriesand instruction
manual 801-646 for installation and operation.
Connect
To
Water Supply
CAUTION
plumbing code regarding cross-connection to
Before attaching to water supply. check local
water supply.
Do
not
exceed
1
60°F (70%) water temperature to
pump
in
a direct supply system.
from your city water supply to the unit's
3/4
in.
Connect a hose with at least a
3/4
in.
(19
mm) ID
garden hose threaded inlet. The supply hose should
not be more than 50 ft.
(15
m)
long.
NOTE:
For a direct supply system. your wafer
AT
LEAST
5
GPM
(19
LITER/MINJ.
source at the
unit
must
have a flow rate of
contact our Customer Service Department for
If your operating conditions are different from above.
assistance.
801-641
3