Filter
Top Products
15309828
ENGINE:
1. Run engine until gas is gone or stabilize the fuel and run it through the fuel system and carburetor.
2. Drain water out of pressure washer hose.
3. Turn fuel system to OFF position.
Pump:
1. Attach one end of a 4 or 5–foot section of hose to pump inlet and other end in an antifreeze solution approx-
imately 1–foot off the ground.
2. Pull pull–cord on engine until antifreeze comes out of pump outlet.
Storage Location:
1. Store pressure washer in garage, basement or other area where it is protected from freezing temperatures.
S Do not store unit outside where it can be exposed to rain, dirt or adverse weather conditions.
S Do not expose pressure washer to freezing temperatures or allow water to freeze in pressure washer
components, causing the pump to lock–up. If this happens let pump thaw naturally in WARM ENVI-
RONMENT. DO NOT attempt to to speed up this process by pouring warm water on pump. This could
cause further damage.
Long Term (more than 30 days)/Winter Storage