Graco 1602 Swing Sets User Manual


 
9
132-7-99 IS1652
10 11 12
Step 1.
With baby out of swing,
open the battery compartment
by gently pressing on the lid at
the ridged area and lifting the
lid.
Step 2.
Insert four D cells. CHECK
that the batteries are put in
correctly. (Swing will not run if
batteries are put in backwards.)
Step 3.
Snap the lid closed.
Installing Batteries
NEVER INSERT OR REMOVE THE
BATTERIES WITH BABY IN THE SEAT. THEY COULD
FALL ON BABY IF DROPPED!
Step 4.
Adjust the control switch to
medium setting.
Step 5.
PUSH SWING SEAT TO START. BE SURE YOU PUSH IT
UP HIGH ENOUGH FOR THE MOTOR TO GET A GOOD
START.
Observe the swinging motion for a minute. It takes time for
your swing to adjust to a new setting.
For a lower speed, push the control switch toward low.
For a higher speed, push the control switch toward high.
A small, quiet baby will swing higher on each setting than a
larger, more active baby.
Using the Tray
Step 1.
Unlatch the tray by squeezing
the two latches under the tray at
the same time, and lift up the
tray. Be careful not to let the
tray hit your baby when lifting or
closing the tray.
Step 2.
To latch tray, push down firmly.
Tray must be
latched at all times when baby
is in the swing. Pull up on
tray to be sure it is latched.
Reclining Back
Four Positions
Pull adjustment wire upward
and pull seat backward to
recline seat. Extra pressure
is needed to go from third
position to full recline.
For upright position, simply lift
back of seat forward.
Caring for Your Battery Powered Swing
Problem:
Swing
won't
operate
Seat
doesn't
swing
very
high
Possible Reasons for Problem:
1. No batteries in swing.
2. Batteries dead.
3. Speed setting too low.
4. Batteries in backwardscheck + and -.
5. Corrosion on battery terminals. Rotate batteries
in place against terminals, or clean with
sandpaper or steel wool if corrosion is severe.
6. Baby leaning too far forward.
7. Baby grabbing swing legs. (Discontinue use.)
8. Seat not pushed high enough for a good start.
9. Protective device activated. (Turn off motor,
wait 3 minutes, then restart swing.)
1. Control setting too low.
2. Blanket hanging down, causing increased
wind resistance.
3. Batteries too weak.
4. Baby leaning too far forward.
5. Baby too heavy or too active. (Discontinue use.)
6. Soft carpet (swings higher on hard floors).
If you still have problems, call our toll-free
number, 1-800-345-4109.
FOR SAFE BATTERY USE:
Do not remove or insert the batteries with
baby in swing. The batteries could fall on
baby if dropped.
Keep the batteries out of childrens reach.
Any battery may leak battery acid if mixed with
a different battery type, if inserted incorrectly
(put in backwards) or if all batteries are not
replaced or recharged at the same time.
Any battery may leak battery acid or explode
if disposed of in fire or an attempt is made to
charge a battery not intended to be recharged.
Never recharge a battery of one type in a
recharger made for a battery of another type.
Discard leaky batteries immediately. Leaky
batteries can cause skin burns or other per-
sonal injury. When discarding batteries, be
sure to dispose of them in the proper manner,
according to your state and local regulations.
Always remove batteries if the swing is not going to be used
for a month or more. Batteries left in the unit may leak and
cause damage.
Recommended Type BatteriesSize D
!
RechargeablesUse and recharge according to
!
manufacturers instructions.
!
DisposablesAlkaline.
!
NEVER mix battery types.
Change batteries when swing ceases to operate satisfactorily.
Toy Mounting System
Your swing has a toy mounting system in the tray. This
swing model does not come equipped with toys. If you
would like to order toys, please see the enclosed leaflet
for information. Please insert the two plastic covers as
described below to fill the holes in the tray.
To Install Covers
To insert a cover into the tray of
your swing, first push one side into
a notch, then push in the other side.
Starting Swing
CHECK that all parts are securely fastened together
before using the swing.
Step 1.
Open tray and seat belt. Place baby in the seat. (If your
child is very small, you may want to use rolled-up blankets
as a prop.)
Step 2.
Place crotch strap between
childs legs and snap both
side buckles to the center
buckle. Adjust belt as needed to
get a snug fit around your child.
Step 3.
Close the tray. CHECK that tray is
latched by lifting up on the tray.
Do not depend
on the tray or seat belt alone to
hold your baby. Always secure
your baby with both the seat
belt and tray when your baby
is in the swing.
Indicator Light-
ON/OFF light comes on
when swing is turned on.
Your seat may be stopped at any time the motor is
running without damaging the motor. Push swing
to restart.
If your swing motor stops operating by itself, a
protective device may have been activated. Turn
off motor, wait three minutes, then restart swing.
If tray does not latch, check back brace to be sure the
word REAR is away from the seat.