Filter
Top Products
11
Important notes when using the blower/
vacuum selector lever
Do not force the lever. The lever should move with
very little resistance. If the lever is difficult to move,
disconnect the power supply, remove the collection bag
and ensure debris, dirt or mud has not jammed the lever
inside the large round outlet.
When selecting either of the operations, ensure the
selector lever is fully in one position or the other, not
half way.
To empty the collection bag
The collection bag is attached to the blower vac in 3
places. It is not necessary to remove the collection bag
from the blower vac when the bag needs to be emptied.
The rear of the bag is fitted with a full length zip.
Simply open the zip and empty the contents.
Ensure to close the zip prior to operating the blower vac.
Tips for using your blower vac
The following points may assist you in the operation of
the blower vac.
• Always try and vacuum dry leaves, cuttings or general
garden debris.
• Wet material is difficult to mulch and also can cause
the blower vac to clog.
• If the leaves etc. are damp, then use the blower vac in
blow selection to pile the leaves etc. into one area, vac
and mulch the leaves when dry.
• Avoid using the vac on areas where there are stones,
or other hard objects. These objects will damage the
impellor of the blower vac.
• It is also advisable not to allow the blower vac to
pick up soil. Soil generally contains moisture and
when combined with other garden debris can clog the
blower vac.
• The blower vac is not a garbage disposal unit. Do not
attempt to mulch any material than general garden
debris.
• For better performance and comfort, it is recommended
the collection bag is emptied when it becomes
approximately half full. This reduces the weight and
also allows the vac operation to perform at its highest
level.
Maintenance and storage information
Prior to cleaning or any maintenance, always ensure the
power plug has been removed from the electrical power
supply.
When you have finished using the blower vac, always
check to make sure the product is clean and free of dirt
and debris. This is important around the selector lever flap
which is just inside the round outlet. To check this area,
remove the collection bag and ensure this area inside the
outlet tube is free of debris and dirt.
Operate the selector lever backwards and forwards to
ensure correct operation.
Do not hose or submerge any part of the blower vac.
Do not use solvents to clean the blower vac.
Store the blower vac in a dry place, and out of reach of
children.
Replacement of the electrical supply cord
If the supply cord of this product is damaged, it must
be replaced by the manufacturer or its service agent, or
similarly qualified person in order to avoid a hazard.