Filter
Top Products
Operator's ManualThird Edition • Second Printing
Part No. 97600 Genie TML-4000 and TML-4000N 15
18 Press and hold the mast rotation lever.
19 Rotate the mast clockwise and then
counterclockwise as far as it will go in either
direction.
Result: The mast should rotate smoothly and
easily in both directions.
20 Rotate the mast back to its original position.
Line up the black arrows on the front of the
mast.
21 Release the mast rotation lever.
22 Attempt to rotate the mast in both directions.
Result: The mast should not rotate.
23 Turn the extend/retract winch handle
counterclockwise until the mast sections are
fully retracted. Line up the blue arrows on the
side of the mast.
Result: No clicking sound should be heard
when the winch handle is turned.
24 Pull and hold the mast release latch below the
control panel.
25 Begin lowering the mast to the horizontal
position by turning the raise/lower winch handle
counterclockwise and holding the release latch
open.
Result: No clicking sound should be heard
when the winch handle is turned.
26 Release the mast release latch and continue to
crank the winch handle counterclockwise until
the mast reaches horizontal position.
Note: Make sure the mast is lowered completely
into the transport cradle. Follow the mast stowing
instructions in the Operating Instructions section to
make sure the mast hold-down latch is securely
locked.
FUNCTION TESTS
Test the Lights
27 Make sure the circuit breaker light switches are
in the off position.
28 Start the engine. See Starting the Engine in the
Operating Instructions section.
29 Turn all four circuit breaker light switches to the
on position.
Result: The lights should come on.
Note: It can take up to 20 minutes for the lights to
reach full intensity. If the lights are turned off and
turned back on while they are still warm, they will
not light up again for 20-30 minutes.
Note: Make sure the circuit breaker light switches
are turned off before shutting down the engine.