Filter
Top Products
12 Genie TML-4000 and TML-4000N Part No. 97600
Operator's Manual Third Edition • Second Printing
MAINTENANCE
Scheduled Maintenance
Maintenance performed quarterly, annually and
every two years must be completed by a person
trained and qualified to perform maintenance on
this machine according to the procedures found in
the service manual for this machine.
Machines that have been out of service for more
than three months must receive the quarterly
inspection before they are put back into service.
Check the Tires and Wheels
Bodily injury hazard. An over-
inflated tire can explode and may
cause death or serious injury.
Collision hazard. An excessively
worn tire can cause poor handling
and continued use could result in
tire failure.
Tip-over hazard. Do not use
temporary flat tire repair products.
Maintaining the tires and wheels in good condition
is essential to safe operation and good
performance. Tire and/or wheel failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1 Check the tire surface and sidewalls for cuts,
cracks, punctures and uneven or excessive
tread wear. Replace the tire if uneven or
excessive tread wear is found.
2 Check each wheel for damage, bends and
cracks. Replace the wheel if any damage is
found.
Tires and wheels must be replaced
with tires and wheels of the
specifications listed.
3 Check each tire with an air pressure gauge and
add air as needed.
4 Check the torque of each lug nut.
Tires and wheels - Standard and Narrow models
Tire size ST185/80D13
Rim size 13 x 4.5 in 33 x 11.4 cm
Lug nut torque 80 ft-lbs 108 Nm
Tire pressure (cold) 50 psi 3.4 bar