Filter
Top Products
Operator's ManualThird Edition • Second Printing
Part No. 97600 Genie TML-4000 and TML-4000N 9
Pre-operation Inspection
o Be sure that the operator’s manual is complete,
legible and in the storage container located on
the machine.
o Be sure that all decals are legible and in place.
See Decals section.
o Check for engine oil leaks and proper fluid level.
Add oil if needed. See Maintenance section.
o Check for engine coolant leaks and proper
coolant level. Add coolant if necessary. See
Maintenance section.
o Check for battery fluid leaks and proper fluid
level. Add distilled water if needed. See
Maintenance section.
o Check for proper tire pressure and lug nut
torque. Add air to tires if needed. See
Maintenance section.
Check the following components or areas for
damage, improperly installed or missing parts and
unauthorized modifications:
o Electrical components, wiring and electrical
cables
o Mast tubes
o Winches and related components
o Latches and pins
o Tires and wheels
o Trailer lights and reflectors
o Outriggers, leveling jacks and foot pads
o Nuts, bolts and other fasteners
o Lamp fixtures and bulbs
o Cable (kinks, frays and abrasions)
o Safety chains (if required)
o Engine and related components
o Fuel tank
o Generator
Check entire machine for:
o Cracks in welds or structural components
o Dents or damage to machine
o Be sure that all structural and other critical
components are present and all associated
fasteners and pins are in place and properly
tightened.
o Be sure that the battery is in place and properly
connected.
PRE-OPERATION INSPECTION