Filter
Top Products
Generac Portable Products SE10000 Generator
4
Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of
your generator, please call the generator helpline
at 1-800-270-1408.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will
result in an engine failure.
REMOVE GENERATOR
FROM CARTON
Set the palleted carton on a rigid flat surface.
Carefully cut bands around the shipping carton.
Lift carton off the generator.
Remove all packing material, carton fillers, etc.
Remove the generator from the shipping pallet.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the generator helpline at
1-800-270-1408. Contents include:
10,000 watt generator
Generator owners manual
Engine owners manual
2 Bottles of SAE 30 engine oil (28 oz.)
Oil fill spout
125 Volt, 30 Amp plug
125 Volt, 20 Amp plug
120/240 Volt, 30 Amp plug
Wheel kit
CHECK BATTERY / ATTACH
NEGATIVE BATTERY WIRE
The battery on the generator is fully charged, sealed
and pre-installed except for the negative (black)
battery cable.
To install:
Remove nut on the negative battery terminal.
Slide the negative battery cable over the screw on
the terminal (Figure 2).
Reattach nut and tighten.
Ensure the connections to the battery and generator
are tight and secure.
Figure 2 Negative Battery Connection