Generac 02010-2, 04164-2 Portable Generator User Manual


 
Generac
®
Power Systems, Inc. 7
Section 2 – Operation
PRIMEPACT 50 Recreational Vehicle Generator
2.1 GENERATOR CONTROL PANEL
The following features are mounted on the generator
control panel (Figure 2.1):
Figure 2.1 – Generator Control Panel
2.1.1 FUEL PRIMER
Before starting a cold engine (if it has not been start-
ed in more than two weeks), you must press this
switch for approximately 10 to 15 seconds to bring
fuel from the tank to the carburetor. This rocker type
switch springs back into its original position when
you release it. It is not necessary to press the primer
switch for LP units.
2.1.2 START/STOP SWITCH
To crank and start the engine, hold this switch in the
START position. Release the switch when the engine
starts. To stop an operating engine, press and hold
the switch in the STOP position until the engine shuts
off. The switch center position is the RUN position.
2.1.3 FUSE
The fuse protects the engine’s DC control circuit
against electrical overload. If the fuse element has
melted open due to overloading, the engine cannot be
cranked. If you must replace the fuse, use only an
identical replacement.
2.1.4 MAIN BREAKER
The main breaker protects the generator’s AC output
circuit against overload and provides a method of
turning OFF the generator’s 120/240-volt AC output
to the vehicle circuits. The PRIMEPACT 50 has one
20-amp breaker and one 30-amp breaker.
NOTE:
If the PRIMEPACT 50 has been reconnected for
dual voltage AC output (120/240 volts), you can
install line breakers having an amperage rating
that is different than that stated in Section 1.4
(Page 5). The replacement line breakers consist of
two separate breakers (one 20 amp, and one 30
amp) with a connecting piece between the breaker
handles (so that both breakers will operate at the
same time). If the unit is reconnected for dual
voltage, it is no longer RVIA listed.
2.2 OPTIONAL REMOTE
START/STOP PANEL
A remote mounted Start/Stop Panel (Figure 2.2) is
available that allows you to start and stop the gener-
ator engine conveniently from inside the vehicle. The
remote panel includes a Start/Stop switch, hourme-
ter, generator run lamp and a wire harness.
Figure 2.2 — Optional Remote Panel
(Models 004057 and 004184)