Generac 005308-0 Portable Generator User Manual


 
15
3.3 GENERAL RECOMMENDATIONS
The warranty of the generator does not cover items that have
been subjected to operator abuse or negligence. To receive full
value from the warranty, the operator must maintain the generator
as instructed in this manual.
Some adjustments will need to be made periodically to properly
maintain the generator.
All adjustments in the Maintenance section (3) of this manual
should be made at least once each season. Follow the
requirements in the "Maintenance Schedule" chart on page 14.
NOTE: Once a year you should replace the spark plug and
replace the air filter. A new spark plug and clean air filter
assure proper fuel-air mixture and help your engine run better
and last longer.
3.3.1 GENERATOR MAINTENANCE
Generator maintenance consists of keeping the unit clean and dry.
Operate and store the unit in a clean dry environment where it will
not be exposed to excessive dust, dirt, moisture or any corrosive
vapors. Cooling air slots in the generator must not become
clogged with snow, leaves, or any other foreign material.
Check the cleanliness of the generator frequently and clean when
dust, dirt, oil, moisture or other foreign substances are visible on
its exterior surface.
ƽCAUTION! Never insert any object or tool through the air
cooling slots, even if the engine is not running.
Note: DO NOT use a garden hose to clean generator. Water can
enter the engine fuel system and cause problems. In addition,
if water enters the generator through cooling air slots, some
water will be retained in voids and crevices of the rotor and
stator winding insulation. Water and dirt buildup on the
generator internal windings will eventually decrease the
insulation resistance of these windings.
3.3.2 TO CLEAN THE GENERATOR
Use a damp cloth to wipe exterior surfaces clean.
A soft, bristle brush may be used to loosen caked on dirt, oil, etc.
A vacuum cleaner may be used to pick up loose dirt and debris.
Low pressure air (not to exceed 25 psi) may be used to blow
away dirt. Inspect cooling air slots and openings on the
generator. These openings must be kept clean and
unobstructed.
3.3.3 ENGINE MAINTENANCE
DANGER! When working on the generator, always disconnect
negative cable from battery. Also disconnect spark plug wires
from spark plug and keep wire away from spark plug.
3.3.4 CHECKING OIL LEVEL
See the “BEFORE STARTING THE GENERATOR” section on page
10 for information on checking the oil level. The oil level should
be checked before each use, or at least every eight hours of
operation. Keep the oil level maintained.
3.3.5 CHANGING THE OIL AND OIL FILTER
Change the oil and filter after the first eight hours of operation.
Change the oil every 100 hours thereafter. If you are running this
unit under dirty or dusty conditions, or in extremely hot weather,
change the oil more often.
Use the following instructions to change the oil while the
engine is still warm:
Clean area around oil drain hose and plug.
Remove oil drain plug from end of hose and oil fill plug to drain
oil completely into a suitable container.
When oil has completely drained, install oil drain plug and
tighten securely.
Place a suitable container beneath the oil filter and turn filter
counterclockwise to remove. Discard according to local
regulations.
Coat gasket of new filter with clean engine oil. Turn filter
clockwise until gasket contacts lightly with filter adapter. Then
tighten an additional 3/4 turn.
Fill oil sump with recommended oil. (See “Before Starting the
Generator” on page 10 for oil recommendations).
Wipe up any spilled oil.
Section 3 — Maintenance
Residential Portable Generator System