Filter
Top Products
16
Blade assembly RS 10, RL10
(Fig. F)
Remove the Accu from the
working unit!
Disassembly
Release both screws (F6) and
remove the complete blade set by
slightly tilting as you remove it.
Assembly
The upper blade must be placed
exactly in the middle of the lower
blade. Turn the cam gear (F1)
so that the marking line (F2) is
pointing exactly forwards.
Firstly guide the blade underneath
the blade peg of the sliding sled
(F3). Make sure that the cam (F4)
snaps into the connecting link (F5).
Tighten screws. (F6).
Blade assembly RL 20 (Fig. F/G)
For the Grass Cutter you
need two sets of Spare Blades,
Art. No. 2346. Please always
replace both sets of blades at
the same time.This avoids pos-
sible imbalance during operation
and prevents damage.
Disassembly
Release the four screws (G3).
Remove the sled (G1) and the com-
plete cutting blade set by slightly
tilting it as you remove it.
Assembly
The upper blade must be situated
exactly in the middle of the corre-
sponding lower blade.Turn the cam
gear (F1) so that the marking line
(F2) is pointing exactly forwards.
Firstly guide each blade underneath
the blade peg of the sled (G2).
Make sure the cam (F4) snaps into
the connecting link (F5). Insert the
sled (G1). Make sure that the
guiding groove fits securely over
the two middle blade ends.
Tighten screws (G3).
Please note: Before inserting
new blades, clean the gear area.
Lubricate the gears with some
noncorrosive grease (Vaseline).
Hold the Grass Shears in correct
working position before the
Accu is clicked in and the unit
is switched on again.
The blades should always be sharp
in order to obtain good cutting
results.They can be sharpened
by using a sharpening stone. We
especially recommend immediate
removal of notches and burrs which
could be caused by stones. The
opportunity to separate the upper
and lower blades makes sharpening
especially easy.
With problems, please contact
one of our Service Centres or send
the defective unit together with
a short description of the problem
and, in case of guarantee, with
a copy of the receipt directly to one
of our Service Centres.
We expressly point out that,
in accordance with the product
liability law, we are not liable
for any damage caused by our
units if, in the case of repair
or exchange, original GARDENA
spare parts are not used and
repair is not carried out by a
GARDENA service centre or an
authorised specialist.The same
also applies to spare parts
and accessories.