Filter
Top Products
14
GB
direction matches the required irrigation limits. If watering in
a complete circle, the two sector stops
z
L
and
z
R
must be
completely pushed together between P1 and P10.
Anti-vandal device:
If the nozzle head is violently turned over the sector-stops then
the vandalism protection is triggered. As soon as the water
supply is open, the sprinkler moves in one direction until the set
sector has been achieved again.
The watering sector has to be selected before programming.
Up to 50 contour points can be programmed with the large-
area pop-up irrigation. The more points that are programmed,
the more precisely the contour will be described (e.g. with a
circular arc P7 – P10).
1. Open the two locks
A
and raise the cover
B
.
2. Open water supply.
When using for the first time, the minimum range (2.5 m with
a flow pressure of 2 bar at the sprinkler) is selected.
3. Press OK button
4
.
The green Auto LED
6
lights up.
4. Press Menu button
1
.
The red Set LED
5
lights up.
5. Turn the nozzle head
0
on the orange ring by hand to the
left-hand sector limit (in the example P1) and hold.
6. Use the two buttons “+” button
2
and “
-
” button
3
to set
the range so that it reaches P1.
7. Press OK button
4
.
The green Auto LED
6
lights up for 1 second and the first
point P1 has been stored.
8. Turn the nozzle head
0
on the orange ring by hand to the
next irrigation point (e.g. P2) and hold.
9. Use the two buttons “+” button
2
and “
-
” button
3
to set
the range so that it reaches P2 for example.
10. Press OK button
4
.
The green Auto LED
6
lights up for 1 second and the point
has been stored.
11. Repeat the process from step 8 to 10 until the right-hand
sector limit is reached (in the example P10).
12. Press Menu button
1
.
The red Set LED
5
goes out,
programming is complete, and
the green Auto LED
6
lights up for 1 minute. The red Set LED
then flashes every 8 seconds.
13. Release nozzle head
0
and check contour area watered.
14. If the contour is watered correctly, close the water supply.
15. Close cover
B
and both locks
A
.
Information about programming:
As soon as the first point is programmed, any existing
programme will be deleted. After programming has been
completed, no further points can be deleted or added later on.
If the contour has not been set as required, reprogramming
with more points will have to be carried out. If no button is
pressed for 60 seconds during programming, programming
will be automatically ended and the contour stored.
Programme contour points
of irrigation sector:
2 4 3
1 6 5
A
B
0