Filter
Top Products
Cutting Head
To remove spool cap
1. Press and hold in the two cap release latches. (T).
2. Pull
cap away from the spoolholder. (T).
When r
efitting the spool cap
1. Keep all areas of the cap and spoolholder clean.
Failure to do so may prevent the cap being securely
located in the spoolholder.
2. Replace the cap, pr
essing firmly DOWN towards
the spoolholder to ensure cap is fully located.
3. Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
T
o r
eplace nylon line.
For your convenience it is recommended you buy spool
and line complete. Nylon line only is also available. Both
are available from Husqvarna Outdoor Products stockists.
T
o fit spool and line complete:
1. Remove old spool.
2. Place new spool into spoolholder with cut out ar
ea of
the spool in line with eyelet as shown in figure V.
3. Release line from cleat and feed line through eyelet (V).
• Ensure spool is fully located by gently rotating it dur-
ing fitment, whilst keeping the spoolholder steady.
4. Refit the cap.
T
o fit nylon line only:
• Remember! Your product is designed to use only
nylon line with a maximum diameter of 1.5mm
.
Use only genuine Flymo nylon line.
1. Take approximately 10 metres of line. Insert 15mm of
line into the hole in the spool (W) and wind line in the
direction of the arrows on the top of the spool. Leave
approximately 100mm of line unwound and place into
cleat as illustrated in figure W1.
2. Care should be taken to ensure that the line is neatly
coiled on the spool. Failure to do so will impair the
efficiency of the automatic line feed.
3. Then fit spool as described in ‘To fit spool and line
complete’, section above.
Cap
Cap release
latch
Spool
Spoolholder
Eyelet
T
V
W
Cleat
Cut out area
of spool
Eyelet
W1
Manual line feed
S
manual line
feed button
To manually feed the nylon line (S)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed but-
ton, whilst gently pulling on the line until it reaches the
line cutter.
3. If the line extends past the line cutter, too much line
has been fed out.
4. If too much line is fed out, remove the spool cap and
click spool anti-clockwise until the line is at the desired
length.