Filter
Top Products
How to trim and edge
• WARNING
• The use of eye protection is recommended.
Do not lean over the trimmer whilst trimming or
edging, objects may be thrown by the cutting line.
Do not allow cutting head to rest on the ground.
Do not overload your trimmer.
Overloading can be avoided by making sure the
motor speed does not drop unduly.
• BEFORE USE
Make sure that the cutting line is fed out.
• Make sure motor is up to full speed before trim-
ming or edging.
To start your Product
1. Attach your product to the fully charged Power
Pack.(J)
• The assembled product is provided with a lock-
off button (K1) to prevent accidental starting.
2. To start, press lock-off button (J1), squeeze the
switch lever (K2), release lock-off button.
How to trim
1. Cut with nylon line at an angle using the tip. (L).
2. Swing trimmer in and out of the cutting area taking
small cuts (M)
3. Line is fed out automatically every time the trimmer
head stops rotating and returns to operating speed.
• Extra line can be fed out manually as described in
Manual line feed
4. To stop your trimmer release the switch lever.
How to edge
1. To convert to edging mode, press button (N1) and
twist head (N2). An audible "click" will confirm that
the head is locked.
2.
To start, press lock-off button (K1), squeeze the
switch lever (K2), release lock-off button.
3. Rest product on wheel for extra stability and line up
the edge of the lawn with the two indicators on the
guard (P1). Edge in direction indicated in Fig P.
4. To stop your product release the switch lever.
5. To return to trimming mode, press button and twist
head back the opposite way. An audible "click" will
confirm that the head is locked.
How to use your product under shrubs & bushes
1. To enable your product to be used under shrubs and
bushes, press the lever at the back of the trimmer
head (Q)
2. Tilt the trimmer head to one of two positions (R)
3. To return to trimming mode, press the lever at the
back of the trimmer head (Q).
L
N
M
1
2
1
P
K
1
2
Q
R
J