Filter
Top Products
8
Hubcap
3
2
ASSEMBLY
F
K3034pr-0920
FRONT VIEW
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery, or
help in assembly of the vehicle.
1
• Fit a long bushing, tapered end first, into the smaller indent in a wheel.
• Fit a snap bushing, narrow end first, into the larger indent in
the wheel.
Long Bushing
Wheel
Cap Nut
Front Axle
• Slide a washer onto a front axle on the steering linkage.
• Next, slide the wheel assembly, long bushing side first, onto the
front axle.
• Fit a cap nut onto the end of the front axle.
• Tap the cap nut with a hammer to secure it on the front axle. Pull on
the wheel to be sure it is secure on the front axle.
Hint: You may need the help of another adult to hold the steering
linkage while you tap the cap nut.
• “Snap” a hubcap onto the center of the wheel.
• Repeat steps 1 and 2 to assemble the other wheel, long bushing,
snap bushing, washer, cap nut and hubcap to the other front axle.
• While lifting the front end of the vehicle, fit the steering linkage onto
the fork. Make sure the center axle is toward the rear of the vehicle.
• Lower the front end of the vehicle.
Fork
Center Axle
Steering Linkage
Snap Bushing
Washer
Steering Linkage
Wheel Assembly
4
• Fit the steering column and power button wire into the large hole in
the cowling. Make sure the steering column goes through the small
slot inside the vehicle.
Hint: Before inserting the steering column, locate the small slot in the
vehicle by looking into the large hole in the cowling.
Power Button Wire
Cowling Large Hole
Steering Column