Filter
Top Products
7
• Position the back panel on a flat surface with the warning
label facing up.
• Insert a shutter lower peg into the lower hinge hole on one
side of the back panel.
• Fit and snap the shutter upper peg into the upper hinge
hole on the same side of the back panel.
• Repeat this procedure to assemble the other shutter to the
back panel.
Upper
Hinge
Hole
Back
Panel
Shutter
Lower Peg
Upper
Peg
Lower
Hinge Hole
Warning Label
• To lock the ladder panel tabs into the back panel slots:
-Climb onto the ladder panel and stomp down until it
snaps into place. (This may require alot of force.)
Assembly
• Stand the assembly upright, as shown.
• Insert the hooked tabs on the ladder panel into the slots in
the back panel.
Back
Panel
Hooked
Tabs
Slots
Ladder Panel
• Position the platform with the wood grain surface upright.
• Insert the long tab next to the half circle cut-out in the
platform into the slot in the ladder panel.
• Insert the two long tabs on the side of the platform into the
slots in the back panel.
Back Panel
Back
Panel
Ladder
Panel
Ladder
Panel
Platform
Half Circle
Cut-out
Slots
Slot
Long Tabs