![](http://pdfasset.owneriq.net/4/d3/4d319a64-9574-4ec4-bd09-704242a1ba89/4d319a64-9574-4ec4-bd09-704242a1ba89-bg3.png)
Assembly
Hole
Threaded Bar
Plastic Screw
Tripod
• Place the projector/telescope upside-down on a flat surface.
• Position the tripod with the rib side facing down.
• Insert the tripod into the center slot on the projector/telescope.
• Align the holes in the projector/telescope with the hole
in the tripod.
• Push the threaded bar through the holes in the projector/telescope
and the tripod.
• Place the plastic screw on the end of the threaded bar and tighten.
Do not over-tighten.
3