Ferris Industries IS4500ZC28D61CE Lawn Mower User Manual


 
Regular Maintenance
20
CHECKING / ADDING FUEL (Gas)
To add fuel:
1. Remove the fuel cap (see A, Figure 11).
2. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.
4. Repeat same process for opposite tank.
NOTE: The fuel tanks are tied together through a “tee”
in the supply lines. By filling only one tank, the level will
balance between the two tanks, effectively having 1/2
tank of fuel for each side.
FUEL FILTER
The fuel filter is located in the fuel line between fuel shut
off valve and fuel pump, behind the hydraulic reservoir.
If filter is dirty or clogged, replace as follows:
1. Shut off the fuel tank selection valve.
2. Disconnect the negative battery cable.
3. Place a container below the filter to catch spilled fuel.
4. Using a pliers, open and slide hose clamps from fuel
filter.
5. Remove hoses from filter.
6. Install new filter in proper flow direction in fuel line.
7. Secure with hose clamps.
8. Reconnect the negative battery cable when finished.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the area.
Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damage
could result.