Ferris Industries BGF36KAV15 Lawn Mower User Manual


 
21
Troubleshooting, Adjustment & Service
PTO CLUTCH ADJUSTMENT
Check the PTO clutch adjustment after the initial 50 hour
break-in period and then after every 250 hours of opera-
tion. Also perform the following procedure if the clutch is
slipping or will not engage, or if a new clutch has been
installed.
1. Remove key from ignition switch and disconnect
spark plug wires to prevent the possibility of acciden-
tal starting while the PTO is being adjusted.
2. See Figure 12. Note the position of the 3 adjustment
windows (A) in the side of the brake plate and the
nylock adjustment nuts (B).
3. Insert a .016”-.018” (0,40-0,45mm) feeler gauge (C)
through each window, positioning the gauge between
the rotor face and the armature face as shown in
Figure 13.
4. Alternately tighten the adjustment nuts (B, Figure 12)
until the rotor face and armature face just contacts
the gauge.
5. Check the windows for an equal amount of tension
when the gauge is inserted and removed, and make
any necessary adjustments by tightening or loosen-
ing the adjustment nuts.
NOTE: The actual air gap between the rotor and arma-
ture may vary even after performing the adjustment pro-
cedure. This is due to dimensional variations on compo-
nent parts, and is an acceptable condition.
6. Check the mower blade stopping time. The mower
blades and mower drive belt should come to a com-
plete stop within five seconds after the electric PTO
switch is turned off.
WARNING
To avoid serious injury, perform adjustments only
with engine stopped, key removed and tractor on
level ground.
Blade Brake Check
Mower blades and mower drive belt should come to a
complete stop within five seconds after electric PTO
switch is turned off.
1. With the gearbox in neutral and PTO disengaged
and the deck guard removed, start the engine
engine.
2. Observe the mower drive belt. Engage the PTO and
wait several seconds. Disengage the PTO and check
the amount of time it takes for the mower drive belt
to stop.
3. If the mower drive belt does not stop within five sec-
onds, perform the PTO Clutch Adjustment. If the belt
still does not stop within 5 seconds, see your dealer.
NOTE: The mower deck is operated with the deck guard
removed for observing the mower drive belt during this
test only. NEVER operate the mower during normal
mowing conditions with the deck guard removed.
B
A
C
A
B
B
B
Figure 12. PTO Clutch Adjustment
A. Adjustment Window (Qty. 3, one shown)
B. Adjustment Nut
Figure 13. Adjust PTO Clutch
A. Window
B. Adjustment Nut
C. .016”-.018” (0,40-0,45mm) Feeler Gauge