Filter
Top Products
English
4
Set-Up
• Open the cabinet door and pull the waste basket (2) completely out of the cabinet.
• Put plastic waste bag in basket (sample bags provided). Allow bag edges to overhang.
Contact Fellowes to order more bags (part # 36052).
• Slide the waste basket into the cabinet and shut the cabinet door (6).
• Plug the power cord into a convenient outlet.
• Store this use and care manual in slot inside cabinet door (6).
Operation
For convenience, your shredder is equipped with an
automatic-start sensor (8)
. This means
that when the control switch (5) is in the automatic [I] position, the shredder will start running
when paper is fed into it. The shredder stops a few seconds after the paper has passed
through. Because the sensor cannot tell the difference between paper and other objects, this
feature can be a hazard, especially to children and pets. To avoid accidents, turn off the
shredder as soon as you are finished. Unplug shredder if it will not be used for an extended
period.
Control Panel (13)
I AUTOMATIC
Turns on the auto-
matic-start sensor
and the green Ready
light.
O OFF
Turns off the auto-
matic-start sensor
and the green Ready
light.
R REVERSE
Runs shredder in
reverse mode. Press
and hold to activate.
Safety Lock Light (
7
)
If the shredder safety
lock is on, the light is
yellow.
13
Troubleshooting Lights
Ready Light (4)
(Green)
Shredder is in automatic start
mode.
Paper Jam (9)
Shredder is jammed
(e.g., too much
paper fed at one time).
Door Ajar (10)
Cabinet is open
Overheat light (11)
Shredder requires cool
down period.
Basket Full (12)
Waste basket is full or
paper has collected
under cutting cylinders.
To shred
• Plug in shredder with control switch (5) in off [O] position
• Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds to
signal readiness and green light (4) will turn on.
PAPER
• Insert the paper you wish to shred inside the sheet capacity measuring gauge
(14) to avoid exceeding maximum sheet capacity. The paper that doesn’t
reach the bottom of the gauge should be set aside for the next shredding
pass. (optional)
• Feed paper straight into entry (1), until the shredder automatically begins shredding; see
Product Profile
for limits on paper width, shreddable items, sheet capacity, etc.
•
Shred for no more than 20 minutes; shredding longer will cause shredder to turn itself off
for 30 minutes to cool down.
9
4
7
10
11
12