Filter
Top Products
3
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
BASIC PRODUCT MAINTENANCE
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
BASIC SHREDDING OPERATION
PAPER JAM
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
Turn the shredder ON
( ) to activate
SafeSense
®
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active
and working properly
DS-3
*Apply oil across entry
Set to Off
Press and hold Reverse
(R) 2-3 seconds
1
3
Gently pull uncut paper
from paper entry. Plug in.
Press and hold Reverse
(R) 2-3 seconds
Set to Off
and unplug
Alternate slowly back and forth
Press and hold
Reverse (R)
5
1
2 3
6
4
DS-3
PAPER/CARD
21
3
Continuous operation:
{xÕÌiÊ>ÝÕ
NOTE:Ê-Ài``iÀÊÀÕÃÊLÀivÞÊ>vÌiÀÊi>VÊ
«>ÃÃÊÌÊVi>ÀÊiÌÀÞ°ÊÌÕÕÃÊ«iÀ>ÌÊ
LiÞ`Ê{xÕÌiÃÊÜÊÌÀ}}iÀÊÊÓäÕÌiÊ
VÊÊ`ÜÊ«iÀ`°
DS-3
2
DS-
3
DS
-3
or
1
2
Feed into paper entry
and release
Press Auto-On ( )
Feed into center of
entry and release
Set to Off
3
4