2
Set to Auto On ( )
Feed paper/card
straight into paper
entry and release
When finished
shredding set to
OFF (
)
PAPER/CARD
Plug in and put
disconnect power
switch in ON (I) position
21 3
Continuous operation: Up to 8 minutes maximum
NOTE: Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 8 minutes will
trigger 20-minute cool down period.
4
CAPABILITIES
BASIC SHREDDING OPERATION
ENGLISH
Model 63Cb
Will shred: Paper, credit cards, staples and small paper clips
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Cross-Cut ......................................................................................................4mm x 50mm
Maximum:
Sheets per pass ........................................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 230mm
* A4 (70g), paper at 220-240V/50/60 Hz, 1.4Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 200 sheets;
10 credit cards.
10 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
15
• Operation,maintenance,andservicerequirementsarecoveredinthe
instruction manual. Read the entire instruction manual before operating
shredders.
• Keepawayfromchildrenandpets.Keephandsawayfrompaperentry.
Always set to off or unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–awayfrom
shredder openings. If object enters top opening, switch to Reverse
( )
to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Donotuseifdamagedordefective.Donotdisassembleshredder.Donot
place near or over heat source or water.
• ThisshredderhasaDisconnectPowerSwitch(E)thatmustbeintheON(I)
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoidtouchingexposedcuttingbladesundershredderhead.
• Shreddermustbepluggedintoaproperlygroundedwalloutletorsocketof
the voltage and amperage designated on the label. The grounded outlet or
socket must be installed near the equipment and easily accessible. Energy
converters, transformers, or extension cords should not be used with this product.
• FIREHAZARD–DoNOTshredgreetingcardswithsoundchipsorbatteries.
• Forindooruseonly.
• Unplugshredderbeforecleaningorservicing.
15
15
KEY
G. Control Switch and Indicator lights
1. Reverse
2. OFF
3. Auto On (blue)
4. SafeSense
®
indicator (yellow)
5. Overheat (red)
6. Door open (red)
7. Remove Paper (red)
A. SafeSense
®
Technology
B. Paper entry
C. Pull-out Bin
D. Window
E. Disconnect power switch
1. OFF
2. ON
F. See safety instructions
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
15
E.
G.
A.
F.
B.
C.
D.