Filter
Top Products
- 11 -
2.3 FUEL SYSTEM
2.3.1 Capacity: 11.2 gal. (42 L.)
2.3.2 Type of Fuel: Regular unleaded gasoline, 87 octane or higher.
2.3.3 Fuel Filter: For Kohler: Replaceable in-line 15 Micron Kohler P/N 2405002
For Kawasaki: Replaceable in-line Kawasaki P/N 49019-2075
2.3.4 Fuel Shut-Off Valve: 1/4 turn increments (left tank, “OFF”, right tank)
2.3.5 Fuel gauge in left hand fuel tank.
2.4 ELECTRICAL SYSTEM
2.4.1 Charging System: Flywheel Alternator
2.4.2 Charging Capacity: 15 amps
2.4.3 Battery Type: BCI Group U1
2.4.4 Battery Voltage: 12 Volt
2.4.5 Polarity: Negative Ground
2.4.6 Fuses: Two 20 amp blade type
2.4.7 Safety Interlock System:
PTO must be disengaged, brake engaged, and motion control levers out
(neutral lock) to start engine. (It is not necessary for the operator to be in the seat
to start the engine.)
Operator must be in seat when PTO is engaged, brake is disengaged, or motion
control levers are moved in or engine will stop.
Engine will stop if either the left, the right, or both levers are moved from neutral
lock position while brake is engaged.
2.5 OPERATOR CONTROLS
2.5.1 Steering and Motion Control:
Separate levers, on each side of the console, control speed and direction of travel
of the respective drive wheels.
Steering is controlled by varying the position of the levers relative to each other.
Moving motion control levers outward
(in slots) locks the drive system in neutral.
Motion control levers are adjustable to two heights.
2.5.2 PTO Switch
: Engages electric clutch (to drive belt) which engages mower blades.
2.5.3 Parking Brake Lever
: Engages parking brakes.
2.5.4 Deck Height Adjustment Lever
: Sets cutting height to desired position.
2.5.5 Deck Lift Assist Lever (standard on 48” & 52” units, optional accessory for 44”
units): Foot pedal that assists in raising the deck.
2.6 SEAT
2.6.1 Type: Standard seat: high back, foam padded (internal spring
suspension) with arm rests.
Optional seat accessories:
• Custom ride suspension system to enhance Standard Seat.
• Deluxe suspension seat with high back, low profile foam-in-place cushion
(dampened, adjustable spring suspension) and armrests.
2.6.2 Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other
components. Held in tilted position with prop rod. Adjustable fore and aft seat track.