Filter
Top Products
- 35 -
Door Opening:
a) Locate the hopper door cables. Loosen the jam nut next to the yoke at the
end of the hopper door cable/shaft assembly on each side and rotate the
shaft until the rear door has a clearance of 1/8”-3/8”. See Figure 22.
b) Verify the cables are pulled equally tight on each side.
c) Tighten the jam nuts against the yokes on each side.
FIGURE 22
HOPPER DOOR ADJUSTMENT
5.2.18 PTO Brake Spring Adjustment
:
PTO brake spring adjustment is only necessary if the blower has been removed
or replaced or if the PTO drive idler arm has been disassembled.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Locate the brake spring and thread the two jam nuts out to the end of the
brake spring rod. See Figure 23.
c) Tighten jam nuts together at end of brake spring rod.
FIGURE 22
PTO BRAKE SPRING ADJUSTMENT
6. WASTE DISPOSAL
6.1 MOTOR OIL DISPOSAL
Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at
a certified recycling center or according to your state and local regulations.