Filter
Top Products
- 8 -
1.6 SAFETY SIGNS
1.6.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety
signs and instructional labels.
1.6.2 Safety signs must be replaced if they are missing or illegible.
1.6.3 When new components are installed, be sure that current safety signs are
affixed to the replaced components.
1.6.4 New safety signs may be obtained from Exmark Mfg. Co. Inc.
1.6.5 Safety signs may be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.6.6 Familiarize yourself with the following safety signs and instruction labels. They
are critical to the safe operation of your Exmark commercial mower.
PART NO. 79-0360
LOCATION: On Front of Blower
Discharge Chute
LOCATION: Molded in LH Console
PART NO. 98-5954
LOCATION: - On Gear Box Cover, Under Rubber Cover
- On Top of Deck, Under Gear Box Cover
- On LH Frame, Under PTO Shield
- On RH Lower Frame, behind fuel tank
PART NO. 1-643401
LOCATION: On Frame, Next to Mercury Switch
or On Mercury Switch
PART NO. 1-523552
LOCATION: On Top of Oil Reservoir
PART NO. 98-4361
LOCATION: - On Top of Pump Mounting Plate
- On PTO Shield
PART NO. 103-8451
LOCATION: On RH Console