Filter
Top Products
22
4.1.3 Clean engine cooling system
:
Service Interval: Daily or more often in dry conditions
CAUTION
POTENTIAL HAZARD
♦ Excessive debris and damaged or
missing rubber baffles can cause the
engine and hydraulic system to overheat.
WHAT CAN HAPPEN
♦ Excessive debris around the engine
cooling air intake and inside of the pump
drive belt compartment can create a fire
hazard.
HOW TO AVOID THE HAZARD
♦ Clean all debris from inside of pump drive
belt compartment daily.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Clean all debris from rotating engine air intake screen and from around
engine shrouding.
c) Clean all debris from inside of pump drive belt compartment.
d) Inspect rubber engine baffles for proper fit. Replace if necessary.
4.1.4 Clean grass build-up under deck
.
Service Interval: Daily
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Raise deck to the transport (4.5” (11.4 cm) cutting height) position. Lift the
front of unit and support unit using jack stands or equivalent support.
CAUTION
POTENTIAL HAZARD
♦ Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may
not be enough support or may
malfunction allowing the unit to fall, which
could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or
hydraulic jacks for support. Use adequate
jack stands or equivalent support.
c) Clean out any grass build-up from underside of deck and in discharge chute.
Information located:
• On console decal 103-3996 below ignition switch
• On decal 1-633462 behind seat on rubber heat
shield flap