Filter
Top Products
12- ENG
A20118
0º 15º 40º Soap
Spray Pattern
Uses
powerful
pinpoint for
very intense
cleaning
intense
cleaning of
small areas
intense
cleaning of
larger areas
applies
cleaning
solutions
Surfaces *
Metal or
concrete
DO NOT use
on wood
metal,
concrete, or
wood
metal,
concrete, or
wood
metal,
concrete,
wood, or vinyl
* The high pressure spray from your pressure
washer is capable of causing damage to surfaces such as wood, glass,
automobile paint, auto striping and trim, and delicate objects such as
fl owers and shrubs. Before spraying, check the item to be cleaned to
assure yourself that it is strong enough to resist damage from the force
of the spray.
To reduce the risk of injury, read the pressure washer instruction
manual and the engine instruction manual before starting pressure
washer.
Risk of fluid injection and laceration. When using the high-pressure
setting, DO NOT allow the high-pressure spray to come in contact
with unprotected skin, eyes, or with any pets or animals. Serious injury will occur.
• Your washer operates at fl uid pressures and velocities high enough to penetrate
human and animal fl esh, which could result in amputation or other serious injury.
Leaks caused by loose fi ttings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician
immediately!
Risk of Fire, Asphyxiation and Burn. NEVER fill fuel tank when
engine is running or hot. Do not smoke when filling fuel tank.
• NEVER fi ll fuel tank completely. Fill tank to 1/2" (12.7 mm) below bottom of fi ller
neck to provide space for fuel expansion. Wipe any fuel spillage from engine and
equipment before starting engine.
• NEVER run engine in doors or in en closed, poorly ven ti lat ed areas. En gine exhaust
con tains carbon mon ox ide, an odorless and deadly gas.
• DO NOT let hoses come in contact with very hot engine muffl er during or
immediately after use of your pressure washer. Damage to hoses from contact with
hot engine surfaces will NOT be covered by warranty.
Risk of property damage. NEVER pull water supply hose to move
pres sure washer. This could damage hose and/or pump inlet.
• DO NOT use hot water, use cold water only.
• NEVER turn water supply off while pressure washer engine is running or damage to
pump will result.
• DO NOT stop spraying water for more than two minutes at a time. Pump operates in
bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode
for more than two minutes internal components of the pump can be damaged.
If you do not understand these precautions, please call 1-800-888-2468 to speak to a
service representative for further instructions.