Filter
Top Products
ET488/ET588
22
Belt/deck lubrication procedure:
Do not lubricate with other than Spirit approved lubricant. Your treadmill comes with one tube of
lubricant and extra tubes can be ordered directly from Spirit or your authorized Spirit dealer. There
are commercially available lube kits, but the only one currently approved by Spirit is Lube-N-Walk.
These kits come with an application wand that makes applying the lubrication easier. The kits can
be purchased directly from Lube-N-Walk here: http://www.jadfitness.com/
. The proper kit should
be silicon based, NOT paraffin wax.
Keeping the deck lubricated at the recommended intervals ensures the longest life possible for
your treadmill. If the lubricant dries out, the friction between the belt and deck rises and places
undue stress on the drive motor, drive belt and electronic motor control board, which could result
in catastrophic failure of these expensive components. Failure to lubricate the deck at regular
intervals may void the warranty.
The belt & deck come pre-lubricated and subsequent lubrication should be performed every 180
hours of use. The console has a built in lubrication reminder indicator that lights every 180 hours
of use. To lubricate the deck with the tube of lubricant supplied it will be necessary to loosen the
walking belt. Using the 6 mm Allen wrench supplied, loosen the two rear roller adjustment bolts --
located in the rear end caps enough to get your hand under the belt (5 10 turns). Make sure to
loosen both bolts the same amount of turns and also remember how many turns, because when
finished you will need to tighten the bolts back to the point they were before.
Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply the
whole tube of lubricant onto the deck surface about 18 inches from the motor cover. Squeeze out
the contents of the tube across the deck (parallel to the motor cover) in about a one-foot line, like
toothpaste on a toothbrush. The one-foot line should be in the middle of the deck at approximately
equal distance from both side edges of the belt. You want the lubricant to be applied about the
spot that your feet would hit the belt as you are walking. This should be about 18 inches from the
motor cover, but you may want to walk on the treadmill before loosening the belt to note where
your feet land on the belt. If you mostly use the treadmill for running, the spot where your feet land
may be different from walking.
Once the lubricant is applied, tighten the rear roller bolts the same amount of turns as when you
loosened them. Run the treadmill at about 3 mph without walking on it for about a minute or two to
make sure the belt stays in the middle of the deck. If the belt tracks to one side then follow the belt
tracking instructions to remedy. Now the deck is lubricated and you should walk, not run, on the
treadmill immediately for at least 5 minutes to ensure the lubricant is evenly distributed. If you
purchase a silicone based Lube-N-Walk kit, follow the instructions that come with it to apply the
lubrication.