Filter
Top Products
4
NOTE:
When performing the following step,
be sure the starter rope is not caught under
the cable clamps.
The starter rope must
hang freely to operate properly.
Cable
clamps
Starter rope
Throttle
cable
7. Align onecable clampabove the tubebolts
and the other below t he starter rope han-
dle. Install the cable clamps one at a time
around the tube and throttle cable.
NOTE:
Ensure throttle cable is in groove of
clamps and lies flat against the upper handle
tube after installation (see illustration above).
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL ANDSAFETYRULES BEFOREOPERATING YOURUNIT.
Compare the illustratio n swith yourunit to familia rize yours elf with the location of the va rious con tr o ls
and adjustments. Save t his manual for future reference.
Primer Bulb
Starter Rope
Handle
ON/OFF
Switch
Throttle Trigger
Choke Lev er
Shield
Shield
Trimmer Head
Muffler
Upper Handle
Lower Handle
ON/OFF SWITCH
The ON/OFF switch is used to stop engine. To
stop the engine, m ove the s w itch to the OFF
position.
PRIMER BULB
The PRIMER BULBremoves airfromthecar-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the s tarter rope. Activate the primer
bulb by pressing it and allowing it to ret urn to
its original form.
CHOKE
The CHOKE helps to supply fuel to t he engine
to aid i n cold star tin g . Activate the cho ke by
moving the choke lever t o the F ULL CH O KE
position. Aftertheengineattemptstostart, m ove
the c hoke l ever to the HALF CHOKE position.
Once engine hasstarted, move the chokelever
to the OFF CHO KE position.